View Single Post

Old 11-26-2007, 07:57 PM #3
Posts: 3,665
ender098 will become famous soon enough -->
Join Date: Dec 2005

Send a message via MSN to ender098 Send a message via Yahoo to ender098

Then Staple the posts every few inches onto the mesh. This takes a little practice. You have to make sure the staples will go THROUGH the mesh and not bend when it hits the mesh. Also, some of the posts are so hard they won’t go in the wood. Use the softer ones you can find in the pack and try not to get frustrated when it takes 15 staples to get 3 good connections.

For the barbed/concertina topping, get 20 – 24 gauge wire (anything less than 20 is too thick and anything greater than 24 is like string!)

and coil it around a pole like a broomstick, snow shovel handle or the occasional Bow Staff you have laying around (that you’re good with and a butt-load of gangs at your school want you to join cause of your skills!)

  Reply With Quote